voestalpine Bohler Welding URANOS 2000 SMC Bedienungsanleitung Seite 21

MMA welding process
Standard MIG/MAG Pulsed MIG/MAG
Welding methods
Allows the selection of the welding method
2 Step
when it is released, the gas, the voltage and the wire feed are turned off.
4 Step
Crater filler
Allows welding to be done with three different power levels able to be directly selected and controlled by
speed set by the "initial increment" parameter (during set up) and with the relative synergic values of the
welding parameters.
automatically to the main values set on the control panel.
pre-set (during set up) crater filler parameter values.
stages.
Voltage - Arc length
Allows the regulation of the arc voltage.
Allows regulation of the arc length during welding.
High voltage = long arc
Low voltage = short arc
Inductance
Allows electronic regulation of the series inductance of the welding circuit.
Makes it possible to obtain a quicker or slower arc to compensate for the welder's movements and for the natural
welding instability.
MMA TIG DC
Minimum Maximum
-5.0 +5.0
Minimum Maximum
-30 +30
21
EQUIPMENT USE
EN
Default
0/syn
Default
0/syn