Option 1: Weed Killer; Option 2: Paint Removal; Option 3: Bbq / Fireplace Lighter - Batavia MAXXHEAT 2000 W Bedienungsanleitung

.
English

OPTION 1: WEED KILLER

Assemble the extension handle
The extension handle consists of two parts.
Connect both parts and tighten the
connection.
Now attach the extension handle to the device.
Make sure that the extension handle firmly
clicks into position. If using the device as a
weed killer you must use the extension handle.
Hold the weed killer firmly by holding the end
of the extension handle.
Use:
• Ensure the extension handle is firmly fixed
onto the device and that the device is
turned off.
• Turn the device to position 1 (see Fig. D)
• Install the nozzle (11) to destroy weeds.
• Insert the plug into the socket
• Check to ensure the nozzle is not blocked
before turning the device on.
• Set the temperature to setting II or III.
• Allow the device about 45 seconds to
warm up.
• To eliminate weeds, hold the nozzle over
the weeds for about 5 seconds. During
these 5 seconds the cell structure of the
weed is destroyed. As a result, the weed
dies within a few days.
• It is not necessary to completely burn the
weeds, 5 seconds is more than sufficient.
• For an efficient treatment the nozzle
should be held around 0 to 5 cm above
the weeds
• The effects are not visible immediately but
will take a while before they can be seen. It
is more of a long-term effect.

OPTION 2: PAINT REMOVAL

The paint removal is always done without the
use of the extension handle. Remove the
extension handle by pressing and releasing
button (7) and pulling the extension handle
from the device.
The paint removal can be used for various
purposes, such as:
• Removing old paint and gloss
• Removing self-adhesive labels
16
7062246_Maxxheat_Ma_#1503-18.indb 16
• Bonding of PVC labels
• Removing vinyl wallpaper
• Fast drying of damp equipment
• Shrink packaging
• Defrosting of water pipes
• Loosening of nuts and bolts
The following standard nozzles are included:
• Glass protection nozzle (13): For the
removal of paint and gloss from window
frames, protecting the window and panes.
• Flat nozzle (12): For a better hot air
distribution.
The device can also be used without a nozzle
attachment.
Use:
• Remove the extension handle
• Turn the device to position 2 (Fig. D)
• Attach the desired nozzle onto the device.
• Insert the plug into the socket
• Check to ensure the nozzle is not blocked
before turning the device on.
• Set the temperature to setting II or III.

OPTION 3: BBQ / FIREPLACE LIGHTER

The BBQ and fireplace lighter is always to be
used without the extension handle. Remove
the extension handle by pressing and releasing
button (7) and pulling the extension handle
from the device.
Use:
• Remove the protective cap (9) from the
device.
• Attach the BBQ nozzle onto the device
• Select temperature setting III.
• Place the nozzle under the coal or the
wood.
• Ensure that the firelighter is properly
positioned
• Insert the plug into the socket
• Check to ensure the nozzle is not blocked
before turning the device on.
• Remove the device from the coals or the
wood as soon as it starts to glow
10-12-15 11:03