Whirlpool ADG 190 A+ Gebrauchsanweisung Seite 48

Turning On the Appliance
Starting a cycle wash:
1. Draw out the lower and upper basket, load the dishes and push them back. It is commended to load
the lower basket first, then the upper one (see the section entitled "Loading the Dishwasher").
2. Pour in the detergent (see the section entitled Salt, "Detergent and Rinse Aid").
3. Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
4. Open the door, press the ON/OFF button, and the ON/OFF light will turn on. Press the program
button to a sired wash cycle. and close the door . After 3 seconds, the machine will work.
Changing the Program...
Premise:
1. A cycle that is underway can only be modified if it has only been running for a short time. Otherwise,
the detergent may have already been released, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled (see the section entitled "Loading the
Detergent").
2. Press current prog. Button more than 3 seconds to cancel the program, then you can change the
program to the desired cycle setting (see the section entitled "Starting a wash cycle. . .").
3. Press one of others prog. Button more than 3 seconds to cancel the runing program, translase the
program which you press.
4. Press the display button more than 3 seconds to re-edit display time.
Forgot to Add a Dish?
A forgotten dish can be added at any time before the detergent dispenser opens.
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Load the forgotten dishes.
4. Close the door; the dishwasher will start running again after 10 seconds.
At the End of the Wash Cycle
When the current cycle has finished, the dishwasher buzzer will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the dishwasher door.
Wait for a few minutes before unloading the dishwasher as the dishes and utensils will still be hot and
more susceptible to breakage. They will also dry better.
Switching Off the Dishwasher
The buzzer of the dishwasher moos for 8 seconds, only in this case the programme has ended.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap!
Opening the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down for around 15
minutes before being removed from the appliance. Open the dishwasher door, leave it ajar and wait a few
minutes before removing the dishes. In this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside. Empty the lower rack first and then the upper one. This will
avoid water dripping from the upper rack onto the dishes in the lower one.
WARNING:
It is dangerous to open the door when washing, because the hot water may scald you.
48