Panasonic NR-BS53VW3 Bedienungsanleitung Seite 8

Installation
Removing the fridge door
When removing the door
● Ensure the door is in the closed position.
● Handle the removed door carefully to keep it safe from damage and impact.
Remove the top hinge cover.
a
Turn the hinge cover screw counterclockwise, and remove it.
b Disconnect the connecting cable.
While pressing on the knob, pull out the cable in the direction shown by the arrow.
c Remove the top hinge.
Turn the hinge screws counterclockwise, and remove them.
● When removing the top hinge, take care to support the door so that it will not topple
forward.
d Remove the door.
● Lift the door straight up from the bottom hinge, and remove it.
Attaching the doors and front grille
Follow the steps for removing the doors and grille in their reverse order.
a
b Tighten up fixing screws after checking that the door is parallel to the body and cold air does not leak from around the
gasket.
c Tighten up screws to fix hinges using both the screwdriver (Phillips head) and hex wrench.
d When installing the front grille and top hinge cover, be sure not to get the hoses and cord caught in.
When attaching the front grille, insert the hoses into the guides inside the front grille.
Connecting the refrigerator to the water supply
Before connecting the refrigerator
A water pressure in the range of approx. 150 kPa to 700 kPa (22 psi to 102 psi) is must be to use the Ice/Water dispenser. If the
refrigerator is to be installed in a location where the water pressure is below approx. 150 kPa (22 psi), install a pressure pump to boost
the natural water pressure.
Connect potable water supply only.
Parts required for the connection
Connection kit (accessory)
8
Hose connector (with strainer)
for G 3/4
Joint (with packing)
for G 1/2
Coupling hose connector
a
b
Knob
Water filter
c