Connecting The Refrigerator To The Water Supply - Panasonic NR-BS53VW3 Bedienungsanleitung

Removing the doors
If the refrigerator will not pass through a doorway or entrance, its doors can be removed.
Before removing the doors, be absolutely sure to check that the power of the refrigerator has been turned off.
When you want to remove the doors, please contact your dealer, an authorized service centre or access to our Web site (http://
panasonic.net).
CAUTION
Panasonic or its Authorized agent cannot be held responsible if you remove the doors by yourself.
Removing the front grille
When the two doors are opened and the front grille is viewed from above, two screws –
one on the left and the other on the right – will be seen.
Turn these screws counterclockwise, and remove them.
There is a connecting area slightly to the right of the centre of the front grille on its bottom.
Take hold of this area, and pull the grille toward you to remove it.
Disconnecting the water supply hoses
Remove the connecting ring (black) of the water supply connector, pressing the coupler
and pull the water supply hose free.
● There are two water supply hoses, one for the Ice dispenser and one for the Water
dispenser.
Disconnect both of them.
Reconnecting the water supply hoses
First insert the connecting ring (black) into the water supply connector, and then
insert the water supply hose.
Insert the water supply hose into the water supply connector until the printed line on
the hose is no longer visible.
● Two water supply hoses connect the same colour.
Line
Removing the freezer door
When removing the door
● Ensure the door is in the closed position.
● Take care not to bend the hinges or damage the water supply hoses.
● Handle the removed door carefully to keep it safe from damage and impact.
Remove the top hinge cover.
a
Turn the hinge cover screw counterclockwise, and remove it.
b Disconnect the connecting cable.
While pressing on the knob, pull out the cable in the direction shown by the arrow.
c Remove the top hinge.
Turn the hinge screws and the grounding screw counterclockwise, and remove them.
● When removing the top hinge, take care to support the door so that it will not topple
forward.
d Remove the hose guide, and remove the door.
Remove the hose guide from the bottom hinge in the direction shown by the arrow.
And then lift the door straight up from the bottom hinge, and remove it.
● Pull out the water supply hoses so that it is completely disconnected.
Dimensions (mm): W910 × D610 × H1855 (Without Door)
Connecting ring
Installation
Front grille
Connecting area
Water supply
Connecting ring
connector
Coupler
a
c
Knob
Hose guide
b
7