Parkside Performance PBSPA 12 E4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 37

Service
1) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
2) Never service damaged battery
packs. Service of battery packs
should only be performed by the
manufacturer or authorized service
providers.
˜ Drill safety warnings
1. Safety instructions for
all operations
1) Hold the power tool by insulated
gripping surfaces, when
performing an operation where the
accessory tool or fasteners may
contact hidden wiring. Accessory
tools or fasteners contacting a "live"
wire may make exposed metal parts
of the power tool "live" and could
give the operator an electric shock.
2. Safety instructions when using
long drill bits
1) Never operate at higher speed
than the maximum speed rating of
the drill bit. At higher speeds, the
drill bit is likely to bend if allowed
to rotate freely without contacting
the workpiece, resulting in personal
injury.
2) Always start drilling at low speed
and with the drill bit tip in contact
with the workpiece.
At higher speeds, the drill bit is likely
to bend if allowed to rotate freely
without contacting the workpiece,
resulting in personal injury.
3) Apply pressure only in direct line
with the drill bit and do not apply
excessive pressure. Drill bits can
bend causing breakage or loss of
control, resulting in personal injury.
˜ Vibration and noise
reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-
noise operating modes as well as wear
personal protective equipment.
Take the following points into account
to minimise the vibration and noise
exposure risks:
Only use the product as intended by
its design and these instructions.
Ensure that the product is in good
condition and well maintained.
Use correct accessory tools for
the product and ensure they are in
good condition.
Keep tight grip on the handles/
grip surface.
Maintain this product in accordance
with these instructions and keep it
well lubricated (where appropriate).
Plan your work schedule to spread
any high vibration tool use across a
longer period of time.
˜ Behaviour in emergency
situations
Familiarise yourself with the use of this
product by means of this instruction
manual. Memorise the safety warnings
and follow them to the letter. This will
help to prevent risks and hazards.
Always be alert when using this
product, so that you can recognise
and handle risks early. Fast
intervention can prevent serious injury
and damage to property.
Switch the product off and
disconnect it from the mains if there
are malfunctions. Have the product
checked by a qualified professional
and repaired, if necessary, before you
operate it again.
GB/IE 35