IKEA FRAMTID DATID Bedienungsanleitung Seite 52

ENGLISH
Gas connection
For information regarding gas connection
instructions, see the injectors table and the
"standard" relevant to your country.
The gas supply system must comply with
current local regulations.
The appliance must be connected to the
gas supply or gas bottle by means of a rigid
copper, steel pipe or rubber hose based on
local regulation (see gas connection table).
The maximum length of the hose is 2 m.
The hose must be connected directly to the
outlet connector (Fig. 1), after first of all
ensuring you remove any extension cable
fitted to your appliance.
IMPORTANT: when using a rubber
i
hose, it must be installed in such a way
as not to be in contact with hot parts on the
rear of the appliance or kitchen. It must pass
through an area free of any hindrances and
in a place where it can be inspected along
its entire length (Fig. 2).
Fig. 1
Fig. 2
When the appliance is connected to the gas
supply, use soapy water to check for gas
leaks.
The rubber hose must be connected as
shown in Fig. 3, 4 and 5, in compliance with
local applicable regulations
FOR FRANCE ONLY: do not install the
conical fitting (B) supplied on the appliance.
Natural gas
Use outlet connector GN for natural gas or
a propane-air mixture.
The rubber hose must be connected to the
outlet connector and secured using hose
clamp (C) (Fig. 4).
A ISO 228-1
B ISO 7-1
Fig. 3
C
Fig. 4
52