IKEA FRAMTID DATID Bedienungsanleitung Seite 38

ENGLISH
How to operate the oven
• Turn the selector knob to the required
function. The oven light switches on.
• Turn the thermostat knob clockwise to
the required temperature. The orange
thermostat led lights up, switching
off again when the oven reaches the
selected temperature.
Cooking time selector
This selector can be used to set a cooking
time of between 1 and 120 minutes.
To set cooking time, after selecting the
required cooking function, turn the knob
clockwise to the desired cooking time. At
the end of the set cooking time the oven
switches off and the selector remains
positioned at "0". To use the oven in
manual mode, i.e. without setting a cooking
time, make sure that the programme
selector is turned to the symbol
IMPORTANT: when the selector is
i
positioned at "0" the oven will not
switch on.
To switch the oven on, set the selector to the
symbol or set a cooking time.
At the end of cooking time:
• Turn the oven control knobs to
How to operate the cooktop
Using the gas burners
The following symbols are given near each
knob on the front panel:
Full circle
Large flame
Small flame
The minimum position is when the knob is
turned fully anticlockwise. All the operating
positions must be chosen between the min.
and max. positions, and never between
max. and off.
Automatic electric ignition
To light one of the burners, press the knob
corresponding to the burner and turn
it anticlockwise to Max. Keep the knob
.
pressed for automatic lighting of the burner.
In case of a power failure or no current, the
burner can also be lit with a match.
Safety valve
To light the burners, carry out the same
operations given above. Once the knobs are
turned to the opening position they must be
kept pressed for about 10 seconds.
If for any reason the burner flame goes
out, the safety valve automatically cuts in,
shutting off the gas to the relevant burner.
"0".
Tap closed
Max. opening
Min opening
38