Parkside PRMA 40-Li A2 Originalbetriebsanleitung Seite 30

GB IE
• Avoid body contact with
earthed surfaces such as pipes,
radiators, cookers and refrigera-
tors. There is an increased risk
of electric shock if your body is
earthed.
• Do not expose electric tools to
rain or wet conditions. The pen-
etration of water into an electric
tool increases the risk of electric
shock.
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for
your battery and charg-
er from the Parkside
X 20 V Team series. A
detailed description of
the charging process
and further information
can be found in the sep-
arate operating instruc-
tions.
Assembly
• Only carry out work that you know you
are capable of.
• If in doubt, consult an expert or our ser-
vice centre directly.
Mounting the lower bar
1. Fold the lower bar (3) upwards.
2. Turn the lower tightening levers (5)
clockwise to fasten.
30
3. Lock the tightening levers (5) by press-
ing them in the direction of the lower
bar (3). The tightening levers must be
pulled tight and then positioned against
the bar so that tightening can be car-
ried out with medium force. If this fails,
continue to turn the tightening lever
clockwise, or loosen it by turning coun-
ter clockwise.
Mounting the upper bar
1. Fasten the upper bar (1) with the en-
closed screws (2b), the washers (2a)
and the upper tightening levers (2) on
the right and left of the lower bar (3).
The release button (16) must be located
on the right in the mowing direction.
Two positions are possible.
2. Turn the tightening levers (2) clockwise
to fasten.
3. Lock the tightening levers (2) by press-
ing them in the direction of the bar (3).
The tightening levers must rest against
the bar in such a way that tightening
can be carried out with medium force.
If this fails, continue to turn the tighten-
ing lever clockwise, or loosen it by
turning counter clockwise (see small
illustration).
4. Clipping in the cable holders:
Clip in the cable holders (14) on the
upper (1) and bottom handle (3) and
use them to fix the device cable (15) in
position. At the end of the bottom han-
dle (3) you can insert the device cable
(15) into an existing cable holder.
On delivery, the cable holders (14)
are already clipped on the upper
(1) and bottom handle (3).
Release the tightening levers (2+5)
and fold the upper bar (1) and the