m-e CUVEO CR-SO2000 Betriebsanleitung Seite 13

All manuals and user guides at all-guides.com
a.) Plug the wireless outlet into a standard
230 VAC / 50Hz mains outlet and press
button (2) until LED (1) flashes red.
b.) Before LED (1) stops flashing, press for
3 seconds the "OFF" button of the switch
channel set to be deleted on the wireless
transmitter for which the wireless outlet
was configured. LED (1) will stop flashing,
indicating that the delete process was
successfully completed.
c.) Repeat these steps for other wireless transmitters.
Delete all configured
wireless transmitters of
the wireless outlet
All configured channels can again
be deleted.
a.) Plug the wireless outlet into a standard
230 VAC / 50Hz mains outlet and press
button (2) until LED (1) flashes red.
b.) Before LED (1) stops flashing, again press
button (2). LED (1) will stop flashing,
indicating that the delete process has been
successfully completed.
FUNCTION TEST
Plug the configured wireless outlet into the
protective contact mains outlet exclusively
provided for it. You can now check the
functioning of the wireless outlet by briefly
pressing the corresponding "ON" button of
the relevant switch channel. The red LED (1)
will flash. The front outlet (3), located at
the front, is now activated and thereby the
mains voltage is connected and an attached
device will also be switched on. Briefly press
the "OFF" button of the corresponding
switch channel on the transmitter, which will
prompt LED (1) to stop flashing, the mains
voltage at the front outlet (3) and the device
connected to it will be switched off.
EN
13