Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10. Connect the gas hose and
regulator using clip and tighten with
screwdriver. Attach the regulator to the
gas cylinder and tighten with
wrench/spanner. Place the propane
gas tank (not included) on the base
(K). Tighten the belt to ensure the
propane gas tank is fully secure.
WARNING! Ensure the hose does not
contact any high temperature
surfaces, or it may melt and leak,
causing a fire.
LEAK CHECK
WARNlNG! A leak test must be performed annually and
each time a cylinder is hooked up or if a part of the gas
system is replaced.
WARNlNG! Never use an open flame to check for gas leaks.
Be certain no sparks or open flames are in the area while
you check for leaks, Sparks or open flames will result in a fire
or explosion, damage to property, serious bodily injury, or
death.
Leak testing: This must be done before initial use, annually,
and whenever any gas components are replaced or
serviced. Do not smoke while performing this test, and
remove all sources of ignition. See Leak Testing Diagram for
areas to check. Turn all burner controls to the off position.
Turn gas supply valve on.
Brush a half-and-half solution of liquid soap and water onto
all joints and connections of the regulator, hose, manifolds
and valves. (As step 6 where arrows show)
35/ 62
Werbung
