HEIDENHAIN ND 780 Handbuch Seite 181

NOMINAL POSITION VALUE
Press the PRESET soft key.
Press the X axis key
- ALTERNATIVE METHOD -
Press the SET/ZERO soft key so that you are in Set
mode.
Press the X axis key.
Enter nominal position value for hole 2: X = 30 mm,
mark your input as an incremental dimension, press I
soft key.
Press ENTER.
Press the Y axis key.
NOMINAL POSITION VALUE
Enter nominal position value for hole 2: Y = 30 mm,
mark your input as an incremental dimension, press I
soft key.
Press ENTER.
Traverse the X and Y axes until the display value is
zero. The square in the graphic positioning aid is now
centered between the two triangular marks.
Press the PRESET soft key.
Press the Z axis key.
ND 780
57