Texas BC 300 Bedienungsanleitung Seite 22

All manuals and user guides at all-guides.com
10. Operation.
Always cut high grass from the top and down. This will prevent grass from getting twisted
around the drive shaft and trimmer head, which can cause overheating and damage. If
grass or the like does get twisted around the drive shaft, STOP engine, detach spark plug
lead and remove.
Trimmer
Twine feed can be controlled by tapping the twine housing against the ground with the
engine at full power.
Hold trimmer at an angle towards the area to be cut.
Figure 10 shows the best cutting zone. Always work from left to right.
Use twine to cut. Do not force twine housing into uncut grass. Wire and fences cause
accelerated wear and can break twine. Stones and bricks, curbstones and wood cause
very rapid twine wear. Work around trees and bushes. Bark and wooden ornaments, wood
cladding and posts can be damaged by the twine.
Bush clearer
Figure 11 shows the best cutting zone. Always work from right to left.
11. Air filter
For correct performance and durability, keep air filter clean.
Remove air filter cover by unscrewing retaining screw.
Clean filter in warm soapy water, allow to dry completely. Soak filter in a little oil. Squeeze
any surplus oil out. If filter is very worn, replace.
Fit filter and cover. Check filter and cover are properly fitted.
Clean filter every 5 hours of operation, more frequently if working in dusty conditions.
12. Spark plug
This machine is fitted with a W22MP-US spark plug with an electrode gap of 0.6 mm.
Replace annually for optimum performance.
13. Storage
Drain all fuel from tank into an approved container. Allow engine to run until it stops.
Clean trimmer and store in frost-free conditions out of the reach of children.
Observe all safety instructions concerning safe storage and handling of gasoline.
www.texas.dk
22