Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The blade should be balanced
around 20 cm above the ground.
1. Loosen the screw (51) on the eyelet
(20) for the double shoulder strap. For
this, use the 4 mm hex key (31), which
is the smaller of the two. Slightly tighten
the screw (51) again.
2. Balance the strimmer according to the
above criteria (depending on the cut-
ting unit chosen) by sliding the eyelet
(20) on the upper shaft tube (19).
3. Tighten the screw (51) once the strim-
mer is in the desired position.
Working using the
thread spool
• On small grass areas, hold the equip-
ment at an angle of approx. 30° and
turn evenly to the right and left with a
semi-circular movement.
• The best results are obtained with maximum
grass length of 15 cm. If the grass is longer,
mowing several times is recommended.
• To cut around trees, fence posts or other ob-
stacles, go slowly around the obstacle with
the equipment and cut with the thread tips.
• Avoid contact with solid obstacles (stones,
walls, board fences etc) otherwise the
thread will quickly wear out. Use the
edge of the protective cover to keep the
equipment at the correct distance
Caution! Do not place the cut-
ting head on the ground dur-
ing operation!
Extending the cutting thread
The equipment comes with a double-thread
tap mechanism, i.e. both threads extend if
the cutting head is tapped on the ground.
1. Hold the equipment in operation over
a grassy area and lightly tap the cut-
ting head a few times on the ground.
This extends the thread.
2. The line cutter (
black protective cover (
the thread to the desired length.
If the thread ends no longer extend:
•
Switch off the equipment.
•
Press the reel insert until it stops and
give a strong pull on the thread end.
If no thread ends are visible:
•
Replace the thread reel (see chapter on
"Changing the Reel").
Caution! Thread remnants
may be thrown out and cause
injuries.
Working using the 3-tooth
blade/clearing blade
Always wear the harness
and suitable protection
clothing when working with the
device. Wear eye, hearing and
head protection.
Ensure that the blade is installed
correctly. Replace damaged or
blunt tool parts.
There is a risk of injury.
Only use the cutting blade to work
on open, even areas. Carefully
inspect the area to be cut and remove all
foreign bodies. Avoid hitting stones, metal
or other obstacles. The blade can be dam-
aged and there is a risk of kickback by the
machine.
• When working, hold the cutter above
the ground and slowly swivel the device
back and forth like a scythe in an equal
GB
MT
49) installed in the
24) cuts off
49
Werbung
