Using The Cooler - Mobicool B40 DC/AC Bedienungsanleitung

B40 DC/AC
7.2

Using the cooler

NOTICE! Risk of damage
A
 Only operate the device from a single energy source.
Simultaneous use of the thermoelectric cooling system and the
compressor is not permitted.
 Ensure that the objects or goods placed in the cooling device
are suitable for cooling to the selected temperature.
 Ensure that food or liquids in glass containers are not
excessively refrigerated. Liquids expand when they freeze and
can therefore destroy glass containers.
 Ensure that your cooler is well ventilated so that any heat
created can dissipate. Otherwise proper functioning cannot be
ensured. It is especially important not to cover the air vents.
➤ Place the cooler on a firm base.
Connecting the cooler to 12 V (thermoelectric mode)
NOTE
I
In thermoelectric mode, the thermostat has no function and the
device cannot deep freeze.
➤ Make sure the cable between the cooler and the battery is protected by a
fuse (maximum 5 A).
➤ Plug the 12-V connection cable (fig. 1 2, page 3) into the cigarette
lighter socket or a 12-V socket in the vehicle.
✓ The cooler starts cooling the interior.
➤ To switch off the cooler:
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for
storage.
NOTE
I
Disconnect the cooler from the battery when the engine is not
running, as otherwise the battery will run down.
Connecting the cooler to 230 V (compressor mode)
➤ Connect the 230-V connection cable (fig. 1 3, page 3) to the 230-V AC
mains supply.
➤ Open the lid of the thermostat (fig. 2 3, page 3) by pressing down on it.
EN
Operation
11