Vulpes Goods CALLUS REMOVER Anleitung Seite 6

USER GUIDE
1. Make sure the callus remover is fully charged before
use. Charge the device for at least 2 hours. Then choose
the desired sanding bit.
2. Be careful not to use the device on the same spot for
more than 5 seconds to avoid irritation.
Want to change the sanding bit? Hold both sides of
the grinding head with your fingers and pull up, so the
grinding head can be easily removed.
3. To install the grinding head, press it down until you
hear a "click," indicating it is properly secured. Check that
the sanding bit is firmly in place before use to prevent
damage.
4. After use, you can clean the callus remover as follows:
First, remove the grinding head and dust off the protector.
Clean the dust on the sanding bit with a cleaning brush.
Do not turn on the device while cleaning.
Do not use salt water, water over 60 degrees, alcohol, or
chemical products when cleaning.
6
COPYRIGHT @ ALL RIGHTS RESERVED BY VULPES GOODS®