Midea SC2 Bedienungsanleitung Seite 9

EN
3-3. Install accessories (hanging ironing head, brush head, small scraper, scouring
head, etc.):
Align the sliding notch on the accessory with the snap on the straight nozzle and
push in. Then rotate the accessory until the snap enters the notch, which
indicates it is installed in place, as shown in Figure 12, Figure 13.
Figure 12 Figure 13
3-4. Modes and operation in handheld state:
Preheating Mode: Check according to the precautions and make sure
everything is OK. Insert the plug into the socket, and the red light on handle will
flash, indicating that the machine enters preheating mode;
Standby Mode: About 15 seconds after entering preheating mode, the red
light will turn on, indicating that the machine switches to standby mode;
High-flow Mode: When the machine is in standby mode, press the ON/OFF
button, and the blue light in the right will turn on, indicating that the machine
switches to high-flow mode (the steam button must be locked);
Low-flow Mode: When the machine is in high-flow mode,
ON/OFF
MODE
press the ON/OFF button, the bluelight in the right will go
out, and the blue light in the middle will turn on,
indicating that the machine switches to low-flow
mode; When the machine is in low-flow mode,
press the ON/OFF button again, all the blue
lights will go out, and the machine will return to
standby mode.
Figure 14
Please see Figure 11 for the position of ON/OFF button.
Note: During the machine is used in handheld state, the steam button must
be locked, otherwise no steam will be ejected.
9