Parkside PSTD 800 C3 Originalbetriebsanleitung Seite 24

GB MT
• Use only undamaged sawblades in
perfect condition. Bent or blunt blades
can break, adversely affect the cut or cause
kickback.
• Do not brake the sawblade after
switching the device off by apply-
ing side pressure. The saw blade may
be damaged, break or cause a kickback.
• Use suitable detectors to determ-
ine if there are hidden supply lines
or contact the local utility company
for assistance. Contact with electric
cables can cause fire and electric shock.
Damaging gas lines can lead to explosion.
Breaking water pipes causes property dam-
age.
• Always wait until the power tool
has come to a complete stop be-
fore placing it down. The application
tool can jam and cause you to lose control
of the power tool.
Safety instructions for
handling the laser
• Caution: Laser radiation - Do not look into
the beam - Laser class 2
• Do not aim the laser at reflective surfaces.
• Markings and warnings are located on the
front of the device.
Residual risks
There will always be residual risks even if you
operate this power tool according to the in-
structions. The following hazards may occur
in connection with the type and design of this
power tool:
• Hearing damage if suitable ear protection
is not worn.
• Health injuries resulting from the effect of vi-
bration on the hands and arms in the event
that the device is used over a longer period
of time or is not used and maintained prop-
erly.
• Cutting injuries
WARNING! Danger due to electromag-
netic field generated while the machine is in
operation. Under certain circumstances, this
field may negatively affect active or pass-
24
ive medical implants. In order to reduce the
danger of serious or fatal injuries, we recom-
mend that individuals who wear medical im-
plants should consult their doctor and the man-
ufacturer of the implant before operating the
machine.
Preparation
WARNING! Risk of injury due to uninten-
tional start-up. Do not insert the plug into the
outlet until the device is fully prepared for use.
Control elements
Familiarise yourself with the operating elements
before using the device for the first time.
• On/Off switch (3)
• Switching on: Press
• Switching off: Release
• Lock button (2)
You can lock the pressed On/off switch by
pressing the lock button.
• Pendulum stroke switch (15)
Set pendulum movement of the saw blade
in 4 positions:
• 0 - no pendulum motion
• 1 - small pendulum motion
• 2 - medium pendulum motion
• 3 - large pendulum motion
• Rotary wheel (1)
Set stroke rate in 6 levels.
• Switch (dust blower function) (12)
Blower function for chip-free cutting line
⭠
disable
• Laser (24) + LED work light (23)
With the changeover switch (26) you can
switch between the different operating
modes:
Off ⭢ Laser + LED work light ⭢ LED work
light ⭢ Laser ⭢ Off...
During the next initial start-up, the device re-
turns to the operating mode that was active
before the power supply was disconnected.
⭢
enable