Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Connecting
Connect the unit to the power supply (make sure the unit is fully grounded) and turn
it on. The unit is now in standby mode. The display flashes (the temperature
indicator lights up when the unit is operating), The WIFI indicator flashes (the WIFI
indicator lights up when the unit is operating).
2. Turn on/off
After connecting, press the power button to turn on the device; Press the power
button again to switch the device to standby; Turning on/off is also possible with
the remote control and APP.
3. Timer shutdown mode
In running mode, press the timer indicator, the timer indicator lights up, each press
on the indicator represents one hour timer, the timer can be set periodically from 0-
24 hours, after the timer is set, the screen flashes for 5 seconds and the timer mode
is activated. In this mode, the device is in Intelligent frequency conversion heating
mode under timing mode; timing mode can only be used with motion sensor
mode;Timing is also possible with remote control and APP.
Intelligent frequency conversion heating under timer mode:The unit operates at
100% power in timer mode, heated up to 23°C; Then switch to 75% power and heat
up to 26°C; Switch to 50% power and heat up to 29°C; Finally switch to 25% power
for heat retention and heating; When the temperature drops, frequency conversion
heating is performed according to the temperature range set above.
Operating Manual
Werbung
