Zeiss EyeMag Light II Gebrauchsanweisung Seite 81

EyeMag Light II
Instructions for Use
5.7. Operation
„ Plug the power supply cable into the power supply connection. If the cable is not
plugged in, or is not plugged in all the way, the indicator LED on the control unit will be
flashing green.
„ To switch on the LED headlamp, press the On/Off button. The LED headlamp is then at
the highest level of intensity.
„ Press the On/Off button several times to run through the following sequence:
- 100% lighting intensity
- 66% lighting intensity
- 33% lighting intensity
- Light off
Press the button again to start the sequence from the beginning. In these states the function
indicator is switched on and shows the charge status.
„ In "Light off" status, the control unit switches off automatically after approximately 2
seconds. When the function indicator is not illuminated, the control unit is switched off.
„ Switch the control unit off in any operating status by pressing and holding the On/Off
button (for approx. 2 seconds).
G-30-2153 V1.5
5. Operation
EN
81