Berner BWDVC 26 Bedienungsanweisungen Seite 15

3 Control / Operation
3.1 Starting and operating of the machine
Check that the electrical switch is switched off (in
position 0). Check that suitable filters are installed in
the machine.Then connect the suction hose into the
suction inlet at the machine by pushing the hose for-
ward until it fits firmly in place at the inlet. Then con-
nect the tube with the hose handle, twist the tube in
order to ensure that they are properly fitted. Attach
suitable nozzle to the tube. Choose nozzle depend-
ing on what type of material that is to be picked-up.
Connect the plug into a proper electrical outlet. Put
the electrical switch into position 1 in order to start
the motor.
Press I : Activate the machine
Press 0 : Stop the machine
3.2 Before wet pick-up
CAUTION
The machine is equipped with a float system
that shuts off the airflow through the machine
when the maximum liquid level is reached.
You will hear a noticeable change of the
sound from the motor and notice that the suc-
tion power decreases. When this occurs,
switch the machine off. Disconnect the ma-
chine from the socket. Never pick up liquid
without the float body in place.
3.3 Emptying after wet pick-up
Before emptying the container, unplug the vacuum
cleaner. Disconnect the hose from the inlet by pulling
out the hose. Release the latch by pulling them out-
wards so that the motor top is released. Open up the
motor top from container. Always empty and clean
the container and the float system after picking-up
liquids. Never pick up liquid without the float system
and filter installed in the machine.
Empty by tilting the container backwards and pour
the liquids into a floor drain or similar.
Put back the motor top to the container. Secure the
motor top with the latches.
3.4 Emptying after dry pick-up
Remove the electrical plug from the socket before
emptying after dry pick-up. Check the filters and
dustbag regularly. Release the latch by pulling them
outwards so that the motor top is released. Open up
the motor top from container.
Cartridge filter: To clean the filter you can either
shake, brush or wash it. Wait until it is dry before you
reuse it.
Dustbag: check bag to ensure the fill factor. Re-
place dust bag if necessary. Remove the old bag.
6
The new bag is fitted by passing the carboard piece with
the rubber membrane through the vacuum inlet. Make sure
that the rubber membrane is passing past the heightening
at the vacuum inlet.
After emptying: Close motor top to the container and se-
cure the motor top with the latches. Never pick up dry
material without cartridge filter and dustbag fitted in the
machine. The suction efficiency of the vacuum cleaner
depends on the size and quality of the filter and dust bag.
Therefore - use only Original filter and dust bags.
3.5 Push&Clean
The machine is equipped with a semi automatic filter
cleaning system. Push&Clean. The filter cleaning system
must be actuated latest when the vacuuming performance
is no longer sufficient. Regular use of the filter cleaning
feature increases the tool life of the filter.
4 After using the cleaner
4.1 After use
Remove the plug from the socket when machine is not
in use. Wind up the cord starting from the machine. The
power cord can be wound up around the motor top or at
the container. Some variants have special storage places
for accessories.
4.2 Transport
• Before transporting the dirt tank, close all the locks.
• Do not tilt the cleaner if there is liquid in the dirt tank.
• Do not use a crane hook to lift the cleaner.
4.3 Storage
Store the appliance in a dry place, protected from
rain and frost. The machine shall be stored indoors
only. Wet filters and the interior part of the liquid con-
tainer shall be dried before storage.
4.4 Disposal
Electrical appliances in accordance with Direc-
tive 2012/19/EU and batteries/rechargeable bat-
teries in accordance with Directive 2006/66/EC
must not be disposed of with household waste.
Electrical appliances and rechargeable batteries must be
collected separately and taken to a recycling company for
environmentally friendly disposal.
If the products contain batteries/rechargeable batteries or
illuminants that can be removed from the old appliance
without destroying it, these must be removed before dis-
posal and disposed of separately as batteries/recharge-
able batteries or illuminants.
Ask the local authorities or your specialist dealer/manufac-
turer about recycling centers and collection points for the
proper disposal of electrical waste and batteries/recharge-
able batteries.
Optional accessories / Option depending on model
*)
CAUTION
Original instruction