Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.3.2. Parameter Modification
In "Parameter Checking" status, press
mode, press
"Parameter Modification" mode, press
2.3.3. Parameter list
NO.
P0
Water Pump Running Way
Time Setting
(Only available when the
P1
water pump running way is
set to "2")
Compressor Continuously
P2
Running Time between
Defrosting Mode
P3
Defrosting Entry Temp
Maximum Defrosting
P4
Running Time
P5
Defrosting Exit Temp
2.3.4. Running status checking
Press
for 5 seconds, enter into "Running status checking", and the screen
alternately shows status point "C0" and its corresponding value. Check all status
points and their corresponding value through
"running status checking" mode.
Running status checking list
Symbol
C0
C1
or
to change the values, then press
Content
Inlet water temp.
Outlet water temp.
to enter the "Parameter Modification"
to quit "Parameter Checking" status.
Adjust range
0: Continuous
1: Water temp control
2: Time/water temp
control
10 ~ 120 min
30 ~ 90 min
-17~0°C / 1~32°F
1 ~ 12 min
8~30°C /46~86°F
or
Content
- 10 -
For users
to confirm and quit
Step length
1
5 min
1 min
1°C /1°F
1 min
1°C /1°F
, Press
to quit
Unit
°C / °F
°C / °F
Werbung
