Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Intended Use
The air milling machine has been exclusively designed for removing weld
points from sheet material.
The intended use also includes an operation following the operating
instructions.
Any use beyond these parameters (different media, applying force) or any
changes (reconstruction, no original accessory) can lead to serious risks and
is regarded as use that is contrary to the intended purpose.
Before first Use
Unpack the air weld point milling machine and check all parts for any damage in
transit. Dispose of packaging materials or store them out of reach of children.
Plastic bags etc. may become a deadly toy for children.
Start-up
1. The air milling machine is equipped with an R ¼" air inlet (7). For your own
safety it is not recommended to use a permanent connection between the air
milling machine and the air hose, but use the supplied quick coupling adaptor
(6) instead. Seal the end of the quick coupling adaptor with Teflon tape before
you screw it onto the air connection of the air milling machine.
2. The milling machine has to be provided with lubricating oil during operation.
Before each use add oil through the air inlet (7) or use an oil-fog lubricator.
Also read the chapter "Lubrication".
3. Use a flexible hose to connect the air milling machine to the compressor. Set
up a pressure of approx. 6 bar on the compressor. Check all air connections for
leakages.
4. Insert the supplied milling drill (9) with the flat side
into the chuck (1) and make sure the set screw (10)
can tighten the milling drill on the flat side. Use the
supplied Allen Key to hand tight the set screw.
5. Secure the workpiece with clamps or similar. Switch on the compressor.
6. Adjust the milling depth with the
adjusting nut (3) so to make sure the
milling drill will just remove the weld
point and will not damage the sheet
material. Turn the adjusting nut
clockwise to increase the milling
Technical Data
11
Werbung
