Makita TW002G Betriebsanleitung Seite 9

Reversing switch action
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
Changing the application mode
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
The level of the impact force changes every time you press the button
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the but-
ton or .
► Fig.7
Application mode
(Impact force grade displayed on
panel)
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
: The lamp is on.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
► Fig.6: 1. Reversing switch lever
Maximum blows
TW001G
-1
2,500 min (/min) 2,400 min
-1
2,400 min (/min) 2,000 min
-1
2,200 min (/min) 1,800 min
-1
1,900 min (/min) 1,700 min
9 ENGLISH
.
TW002G
-1
(/min) Tightening with the maximum force
and speed.
Tightening when the force and the
speed are desired.
-1
(/min) Tightening with less force and speed
than Max mode (easier to control than
Max mode).
Tightening when the force and the
speed are desired.
-1
(/min) Tightening with less force to avoid
screw thread breakage.
Tightening when you need good
control power.
-1
(/min) Tightening with less force to avoid
screw thread breakage.
Tightening when you need fine adjust-
ment with small diameter bolts.
Purpose
.