Ip Dhcp-Snooping Limit - Hirschmann HiOS-2A GRS1040 Referenzhandbuch

DHCP Snooping

18.4.4 ip dhcp-snooping limit

This command configures an interface for a maximum DHCP packet rate in
a burst interval, or disables it. If the rate of DHCP packets exceed this limit in
consecutive intervals then all further packets are dropped. If that happens
and additionally the auto-disable feature is enabled, then the port is disabled
automatically.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip dhcp-snooping limit <P-1> [<P-2>]
Parameter Value
-1..150
P-1
1..15
P-2
RM CLI HiOS-2A GRS1040
Release 6.1 09/2016
Meaning
Specifies the rate limit value (in packets
per seconds, pps) for DHCP snooping purpo-
ses. The value -1 switches rate limiting
off.
Specifies the burst interval value for DHCP
snooping purposes. Because this parameter is
optional it leaves unchanged if omitted.
18.4 ip
273