Flex LD 16-8 125R Originalbetriebsanleitung Seite 22

Instructions for use
Before initial operation
Unpack the power tool and accessories and
check that no parts are missing or were
damaged during transport.
Operation with protective hood
WARNING!
Before performing any work on the power
tool, pull out the mains plug.
Attaching the protective hood
 Loosen and remove the locking screw (1.).
 Push the protective hood over the pins on
the housing (2.).
 Install the locking screw (3.).
 Remove the protective hood in the reverse
order.
Adjusting the bail handle
22
Attaching the Velcro plate
 Fit hook-and-pile plate on spindle.
 Screw securing screw into thread.
 Counterhold hook-and-pile plate in anti-
clockwise direction using stop wrench (1.).
 Tighten securing screw in clockwise
direction using ring spanner (2.).
 Place sanding tool in the centre of the
Velcro pad .
Attaching the diamond sanding plate
 Fit diamond grinding wheel on spindle.
 Screw securing screw into thread.
 Hold diamond grinding wheel in anti-
clockwise direction using stop wrench (1.).
 Tighten securing screw in clockwise
direction using ring spanner (to at least
25 Nm) (2.).
RE 16-5 115