Scheppach AB1600 Originalbetriebsanleitung Seite 20

The specified vibration value can be used for initial as-
sessment of a harmful effect.
Keep the noise emissions and vibrations to a min-
imum!
• Only use appliances which are in perfect working or-
der.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
• Wear protective gloves.
Residual risks
Even if you use this electric power tool in accord-
ance with instructions, certain residual risks can-
not be rules out. The following hazards may arise
in connection with the equipment's construction
and layout:
1. Lung damage if no suitable protective dust mask is
used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
Before starting the equipment
Before you connect the equipment to the mains supply
make sure that the data on the rating plate are identi-
cal to the mains data.
Always pull the power plug before making adjustments
to the equipment.
• Get to know your machine. Familiarise yourself with
its application and limitations, as well as the specific
potential hazards.
• Make sure that the switch is OFF before inserting
the plug into the socket.
• Make sure that the machine is assembled complete-
ly and properly.
• Check the machine before use for damaged parts
and determine whether these parts work properly
and perform its intended function; in case of doubt,
the part is to be replaced.
20 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Check the alignment of all moving parts, broken or
mounting parts, and other conditions that could im-
pair proper operation. Any damaged part should be
repaired or replaced by a qualified technician.
• Do not use the machine if a switch cannot be
switched on and off correctly.
Caution! Before beginning the operation, check the
installation site for concealed electrical cables, gas
and water pipes using a pipe locator..
Operation
□ Use only proper equipment.
□ Make all machine adjustments only with the machine
switched off.
□ Never leave the machine unattended while it is run-
ning.
□ When switching off, leave the machine only after it
comes to a complete standstill.
□ Turn the machine off before you unplug it.
□ Always unplug the mains cord. Never pull out the
plug from the wall outlet by holding the cable.
□ Perform maintenance and cleaning of the device
regularly.
Starting up
Using the chisel Fig. 2
1 Clean chisel always before inserting it and lubricate
the shaft slightly.
2 Pull out the locking bolts (6) up to the end stop, turn
by 180° and release.
3 Insert chisel into the tool holder (5) and slide it up to
the end stop.
4 Pull out the locking bolts (6) once again, turn by 180°
and release.
5 Check lock on the tool.
Remove chisel
Pull out the locking bolts (6) up to the end stop, turn by
180° and release, and remove the chisel.
Additional handle Fig.3
For safety reasons, use the demolition hammer
only with the additional handle!
1 The additional handle (4) provides you safe grip
while using the demolition hammer.
2 The additional handle (4) can be rotated to any po-
sition.