Power Supply; General Functions - PERFECTPRO Work Station 2 Bedienungsanleitung

POWER SUPPLY

Battery operation
1. To open the battery compartment, first turn the battery cover fixtures anti-clockwise
to loosen and pull down the battery cover.
2. Insert 6 x D size (UM-1) battery with the correct polarity into the compartment.
Close the battery cover and fasten the fixtures by turning clockwise.
3. If the unit is not to be used for any extended period of time, it is recommended to
remove the batteries from the radio.
The approximate power level of the batteries is displayed in the LCD display of the radio.
When the power level is very low the indication "Battery Low!" appears and the battery
symbol flashes on the display. The batteries should then be replaced soon to continue
normal operation of the radio.
Back up battery
Back up battery is to back up the preset stations and the clock. It is necessary to insert
back up battery (2 x AA size / UM-3) for memory back up even if you use AC power
supply only. Without the back up battery, time and preset station will get lost if you
remove the AC power cord from AC socket or during power failure.
Warning: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type. Do not expose the batteries to excessive heat such as
sunshine, fire or the like. Batteries should not be disposed of by incineration and with
household waste. Disposable batteries should be taken to a suitable recycling centre if
possible.
AC operation
Before plugging the AC power cord into the AC socket, be sure the voltage is correct.
If you have batteries in the radio and using the AC power supply, the batteries will
automatically be disconnect. AC power cord storage is designed to store the cord when
the radio is not in use.
Note: In order to disconnect the unit from the mains completely, the AC plug should be
removed from the mains socket completely.
5

GENERAL FUNCTIONS

1. Switching on and off
Press the On/Off button to turn the radio on or in standby.
2. Switching among DAB / FM / Bluetooth / AUX IN modes
Press the Source button to switch between modes.
3. Tuning the Radio
Tune the radio using the Tuning knob on the right.
4. Adjusting the Volume
Adjust the volume with the Volume knob on the left.
5. Adjusting the Tone
Press the Volume knob on the left and rotate it to adjust the Bass and Treble.
6. Selecting Stereo or Mono mode (in FM mode only)
Press the Mono/Stereo button to switch between FM Mono or FM Stereo.
7. Anti-Theft-Protection (ATP) System
Press the preset buttons (1-10) to enter the 4-digits numeric passcode.
8. Listening music via Bluetooth streaming
Play music from your paired Bluetooth device with your radio.
GB
6