Power Supply; Battery Operation; Ac Operation - PERFECTPRO Slim 2 Bedienungsanleitung

CONTROLS
16. ANTENNA
17. AUX-IN
18. BATTERY COMPARTMENT
19. POWER CORD / PLUG STORAGE
5
18
16
19
17

POWER SUPPLY

Battery operation

1. To open the battery compartment, first turn the battery cover fixtures anti-clockwise
to loosen and open the battery cover.
2. Insert 6 x AM3/AA/LR6 NiMH or alkaline batteries with the correct polarity into the
compartment. Close the battery cover and fasten the fixtures by turning clockwise.
Close well to prevent moist or dust from entering the compartment.
3. If the unit is not to be used for any extended period of time, it is recommended to
remove the batteries from the radio.
The approximate power level of the batteries is displayed in the LCD display of the
radio. When the power level is very low the battery symbol flashes on the display.
The batteries should then be replaced soon to continue normal operation of the
radio.
Notes:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Do not expose the batteries to excessive heat such as sunshine, fire or the like.
Batteries should not be disposed of by incineration and with household waste.
Disposable batteries should be taken to a suitable recycling centre if possible.

AC operation

Before plugging the AC power cord into the AC socket, be sure the voltage is correct.
If you have batteries in the radio and using the AC power supply, the batteries will
automatically be disconnect.
AC power cord and plug storage are designed to store the cord and plug when the radio
is not in use or playing on batteries.
Note:
In order to disconnect the unit from the AC mains completely, the AC power cord should
be removed from the mains socket completely. The AC power cord shall remain readily
operable and should not be obstructed during intended use.
In case of malfunction due to electrostatic discharge or fast transient (burst), remove the
power supply and all the batteries then reinstall the batteries and reconnect the power
supply.
GB
6