Silvercrest SHGB 50 C3 Bedienungs- Und Sicherheitshinweise Seite 9

Clean all parts of the product as described in
o
the chapter "Cleaning and care" .
˜ Operation
NOTE: The product may give off some odour
during first use . This is due to production or
transport residues that will quickly subside .
Ensure sufficient ventilation in the area .
˜ Switching on/off and setting
the temperature
m WARNING! Risk of burns! The product
becomes very hot during use . Never touch the
ceramic coating of the brush insert
the product is switched on and cooling down .
Always hold the product by its handle
Never place the switched-on/hot product on
a table . If necessary, only place the product
on a flat, heat-resistant surface and away
from other objects .
1 . Connect the mains plug
mains socket .
2 . Press the button
to switch on the product . 100 °C flashes on
the display , the product starts to heat up .
[ 2 ]
3 . Use the /
3 ] [
temperature between 100 °C and 200 °C in
10 °C increments . The set temperature starts
flashing on the display
selected temperature is reached, the display
lights up permanently .
4 . Hold down the
2 seconds to switch off the product .
5 . After use: Disconnect the mains plug
the mains socket . Allow the product to cool
down completely .
˜ Key lock
To prevent accidentally changing the temperature
during straightening, you can manually activate
the key lock .
1 . Hold down the
2 seconds . The buttons are locked when the
lock symbol is shown on the display
10 GB/IE/NI
when
1 ] [
8 ] [
to a suitable
[ 7 ]
for approx . 2 seconds
[ 5 ]
buttons to set a
[ 4 ]
. As soon as the
2 ] [
button for approx .
5 ] [
from
7 ] [
button for approx .
3 ] [
2 ] [
2 . Press the
2 seconds to deactivate the key lock . The
buttons are unlocked when the lock symbol
goes off from the display
3 . Switching off a locked product: Press and
hold the
˜ Memory function
The memory function preserves the last
o
temperature setting that was selected during
the previous use .
The memory is cleared after the mains
o
plug is removed from the mains socket .
[ 7 ]
˜ Standby mode
If the product is connected to the mains
o
.
supply and no button is pressed: The product
enters the standby mode automatically . The
display
[ 2 ]
If the product is switched on for about
o
40 minutes, °C starts to flash in the
display
[ 2 ]
switches to standby mode automatically and
the display
Hold down the
o
2 seconds to switch the product back on .
NOTE: The standby mode is not intended as
a replacement for switching the product off
properly using the
˜ Selecting the right
temperature
Type of hair
Bleached/lightened hair
Fine and colour-treated
hair
Normal natural hair
Strong and resistant hair
Start at the lowest recommended temperature
o
(see above table) .
.
button again for approx .
3 ] [
.
2 ] [
button for approx . 2 seconds .
5 ] [
does not light up .
. After 45 minutes, the product
goes off .
[ 2 ]
button for approx .
5 ] [
button .
5 ] [
Recommended
temperature
100–160 °C
100–160 °C
160–170 °C
170–200 °C