Changing The Select Key Sets - G&D DL-MUX2-MC2 Bedienungsanleitung

Configuration

Changing the select key sets

The select keys 1
between the computers that are connected to the KVM switch.
EXAMPLE:
Press
If one of the key combinations of the select key set interferes with a key combination
of an installed application program, the hotkey (see page 19) and the select key set
can be changed.
How to change the select key set:
1. Press Hotkey+Backspace
If the hotkey delay is activated, press the key combination during the adjusted time
(default: 7 seconds).
2. Press one of the following setup keys to activate a particular select key set.
1  activate select key sets
Num1  activate select key sets
Y  activate select key sets
F1  activate select key sets
1. Use the tree view to click on
2. Right-click the KVM switch and click on the
text menu.
3. Click the General
4. Use the Select Key
lowing options:
1...2
Num1...2
A...B
F1...F2
5. Click OK to save your changes.
20 · G&D DL-MUX2-MC2
to 2 (set » 1...2 «) are activated in the default settings to switch
Hotkey+2 (default:
(default:
tab.
field of the
 activate select key sets
 activate select key sets
 activate select key sets
 activate select key sets
Ctrl+2 ) to switch to computer 2.
Ctrl + Backspace
1 , 2
Num1 , Num2
A , B
F1 , F2
KVM switches > [All switches]
Configuration
Configuration paragraph to select one of the fol-
,
1 2
Num1 , Num2
A , B
F1 , F2
) to activate the setup mode.
.
entry in the con-