Werbung
CARE AND CLEANING
Do not use harsh abrasives, chemical cleaners or solvents to clean the exte-
rior of your steam generator because they will damage the surface.
After each use
After each use, allow your steam generator to completely cool down before
wiping the soleplate with a soft damp cloth. If polyester has burnt to the
soleplate, iron a damp cotton cloth while your steam generator is still hot. If
necessary, allow your steam generator to completely cool down then wipe
over the soleplate with a soft cloth moistened with methylated spirits. Re-
move the methylated spirit with a damp cloth. Make sure that the soleplate
is completely dry.
To clean the exterior of your steam generator, wipe over with a soft damp
cloth and wipe dry. Ensure the soleplate is dry.
To remove build-up from the steam holes which may affect steam perfor-
mance, use a cotton wool tip moistened in methylated spirits. Wipe over
with a damp cloth.
Rinsing out the boiler
NEVER
remove the boiler rinse plug when your steam generator is hot.
Allow your steam generator to cool for at least 2 hours before removing the
boiler rinse plug.
To maintain optimum performance, it is important to rinse out the boiler in
your steam generator once a month or after every 10 times you have used it.
Unplug your steam generator and allow it to cool for at least 2 hours. Re-
move the water tank.
1. Remove the iron from the iron rest and place it to one side. Shake the
base unit for a few seconds.
2. Remove the boiler rinse plug cover by pulling it away from the base unit.
3. Use a coin to unscrew the boiler rinse plug.
4. Place the base unit on its side and and pour about 300ml (approx. equal
to 1 coffee mug) of cold tap water into the opening.
5. Shake the base unit again for a few seconds to agitate the water in the
boiler.
6. Pour out the water into a sink.
7. Repeat steps 4, 5 and 6 again.
8. Refit the boiler rinse plug and tighten it firmly using a coin.
9. Refit the boiler rinse plug cover.
10
Werbung
