Hisense AH-200NH4GHB Installations-/ Betriebshandbuch Seite 43

than 60 seconds it will get automatically locked. Press the key "
unlock, it will beep.
2) Turn ON/OFF the heat pump:
When the controller is in the normal display mode, press "
second to switch the controller to the power ON or OFF mode.
3) Operation mode selection:
When the controller is in normal display mode, press "M" key to show the existing operation
mode, it will display constantly for 8 seconds, before it disappear, press "M" again to switch
between different operating modes;
The mode name will show at the clock area for 8 seconds each time when you touch "M"
key, when unlock, the area will show clock, pressing "M" key one time will query the existing
operation mode.
The system default mode is STAN mode; When the unit is switched on for the first time ,the
system will operate under STAN mode, later on the unit will always start as per previous
setting mode. For changing the mode, refer below instructions:
Operation Modes Chart With Symbols
S.No. Mode
01. Standard Mode
02. Economic Mode
03. Hybrid Mode
03. Hybrid Mode 1
04. Electric Mode
STAN mode (Standard mode):
In STAN mode, the controller will display "
and the default water temperature setting is 55° C, setting range is 15° C~60° C, restart
temperature difference is 5° C.
ECO mode (Economic mode):
In ECO mode, the controller will display "
and the default water temperature setting is 55° C, setting range is 15° C~60° C, restart
temperature difference is 12° C.
HYB mode (Hybrid mode):
Symbol
STAN
ECO
HYB
HYB1
ELE
", in this mode only heat pump operates
", in this mode only heat pump operates
Heat Pump Water Heater
" for 3 seconds to
" button for more than 1
Setting Range
15° C~60° C
15° C~60° C
15° C~65° C
15° C~65° C
15° C~70° C
- 41 - / 54