Sentiotec CK 3 Gebrauchsanweisung Seite 46

Sauna operation
6 Manual operation, quick-start
Continued
6.3 Entering the heating duration (00:00 -
6:00)
1. Press UP/DOWN buttons 8 until the LED TIME
E lights up:
The display 6 indicates (in standby):
STOP
or the remaining heating time while in operation.
2. Press PROG/OK 9:
The display 6 flashes:
06:00
or the value set previously.
3. Use the UP/DOWN buttons 8 to enter the desired
value, e.g. [02:30].
The display 6 flashes:
02:30
4. Press PROG/OK 9:
The display 6 indicates (in standby):
STOP
or the new value entered while in heating opera-
tion.
The heating duration has been set.
6.4 Starting the sauna control
1. Press START/STOP 7:
The display 6 indicates the remaining heating
time, e.g.:
02:30
The heater starts heating.
The LED 4 lights up.
6.5 View/Change settings
You can view and change the temperature settings,
heating duration and fan settings while the sauna is
in operation.
46
Operating instructions for the user 9
Sauna operation
6 Manual operation, quick-start
Continued
6.5.1 How to change target values
1. Press PROG/OK 9:
In display 6 the respective, current setting will
flash.
2. Use the UP/DOWN buttons 8 to enter the desired
value.
3. Press PROG/OK 9:
The new value has been set.
6.6 Switching off the sauna control
6.6.1 Manually
Press START/STOP 7:
The sauna heater turns off.
The LED HEAT 4 goes out.
The control is turned off.
6.6.2 Automatically
The sauna control automatically switches of the heater
when the set heating time has lapsed (see chapter 6.3).
- You will hear a continuous beep for 10 seconds.
The LED HEAT 4 goes out.
-
- The control is turned off.