Auriol 436833 2304 Bedienungsanleitung Seite 17

Note: You can install the radio-controlled weather station and the outdoor sensor
on a surface or hang it on a wall using suspension eyes 2 22 .
Note: Ensure sufficient ventilation of the radio-controlled weather station and keep
the ventilation slots free from obstruction 5 .
● Commissioning the outdoor sensor
□ Open the battery compartment 20 on the back of the outdoor sensor by
sliding the battery compartment cover 21 in the direction indicated by the
arrow.
□ Remove the spent batteries first (if applicable).
□ Insert two AAA batteries into the battery compartment 20 . Observe the correct
polarity (+/-).
The control LED 23 on the front of the outdoor sensor flashes briefly.
The temperature 59 and the air humidity 58 are displayed.
□ Close the battery compartment 20 on the back of the outdoor sensor by sliding
the battery compartment cover 21 in the opposite direction to that indicated by
the arrow.
Note: The control LED 23 flashes once per minute to signal radio transmission.
● Commissioning the radio-controlled
weather station
Note: If the batteries are removed or empty, all settings are deleted.
Note: After inserting the batteries, you have 20 seconds to set the air pressure
and the weather display 35 (see section "Automatic signal detection").
28
□ Open the battery compartment 7 on the back of the radio-controlled weather
station by opening the battery compartment cover 8 .
□ Remove the spent batteries first (if applicable).
Start-up
GB/IE/NI 17