Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Functions
• Capable of multi-protocols: fx (MM) and DCC
• Setting the mode of operation by means of DIP switches, see
Page 38
• Addresses can be set with DIP switches:
1-256 fx (MM) (Control Unit 6021/Mobile Station 60651/652)
1-320 fx (MM) (Central Station 6021x/Mobile Station 60653)
1-511 (DCC)
• Programmable addresses using CVs
1-2,044 DCC
• The last respective address setting is valid, regardless of
whether it was done with programming or with the DIP
switches
• Changes to characteristics can be done with CVs
• Digital signal: transfer independent of the power supply
• Power supply done using the digital power circuit
• Alternative power supply
• Solder pads for connections for turnout lanterns
• Turnout lanterns can be turned on or off
8
Decoder Installation
The following work steps may only be done in a voltage-free
work environment:
• Plug the cable included with the decoder (pay attention to the
track system) in the socket provided for it – see page 28/29
(Märklin and Trix). Now follow the illustrated instructions.
See the section "CV Programming" for changes to other charac-
teristics in the fx (MM) protocol using CV programming or to the
DCC CV programming.
Note: Settings with the DIP switches are to be only when the
voltage is turned off. The digital installation decoder does not
recognize the current switch settings until the voltage is turned
on.
Starting on page 39 you'll find the table for setting addresses
with DIP switches.
See page 28 for installation of the digital installation decoder
in Märklin standard turnouts, curved turnouts, or double slip
switches.
Alternative Power Supply page 31
See page 29 for installation of the digital installation decoder in
Trix standard turnouts, curved turnouts, or double slip switches.
Alternative Power Supply page 31
Werbung
