Safety Regulations; Layout; Proper Use; Technical Data - EINHELL BT-LS 610 B Originalbetriebsanleitung

Anleitung_BT_LS_610_B_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout and items supplied
(Fig. 1-38)
1. Splitter
2. Trunk support
3. Hand guards (2x)
4. Control lever
5. Trunk support holder
6. Supporting foot
7. Wheels (2x)
8. Switch/plug combination
9. Motor
10. Transport handle
11. Trunk holding plates with securing screws and
star nuts (2x)
12. Chain for adjusting the splitter height
13. Screws for switch/plug combination (4x)
14. Axle
15. Washers for axle (2x)
16. Securing split pins for axle (2x)
17. Chain hook
18. Oil filler screw
19. Guard plates (2x)
20. Screws for fitting the hand guards (2x)
21. Velcro fastener (transport brace for control lever)
22. Safety bar (2x)
23. Screws for safety bars (4x)
24. Washers for safety bars (6x)
20.04.2011 11:56 Uhr Seite 19
25. Locking rings for safety bars (6x)
26. Nuts for safety bars (6x)
27. Fixing points
28. Steel dowels (2x)
29. Handle screw (2x)

3. Proper use

The wood splitter is designed for splitting wood with
maximum lengths of 520/770/1040 mm and a
maximum diameter of 320 mm.
The trunk diameters given above are indicative only.
Thin pieces of wood can be very difficult to split if
they contain knot holes or have very tough fibers. On
the other hand, it may be possible to split thicker
pieces of wood if they have smooth and loose fibers.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Voltage:
Power rating:
Idle speed:
Protection type:
Max. splitting force:
Splitting lift:
Trunk holding capacity:
Diameter:
Length:
Oil quantity:
Weight:
GB
230 V ~ 50 Hz
2200 W
2950 rpm
IP 54
6 t
470 mm
50 -320 mm
100 -1040 mm
3.8 l
83 kg
19