Xiaomi MJST1SHW Bedienungsanleitung Seite 14

Rese ing Wi-Fi
When switching to a new router or changing your Wi-Fi password, you will
need to reset the vacuum-mop's Wi-Fi connection. To do so, turn on the
vacuum-mop, then simultaneously press and hold the bu ons
for 7 seconds until you hear a voice saying "Rese ing the Wi-Fi connection
and entering network configuration mode". Once the Wi-Fi connection is
reset, you can reconnect the vacuum-mop.
Note: Only 2.4 GHz Wi-Fi networks are supported.
Rese ing/Restoring the system
To reset the system: Use a pin to press and hold the reset bu on for 3
seconds until you hear a voice saying "System reset successfully". Then
the vacuum-mop will automatically restart, and the se ings such as
scheduled cleanup and Wi-Fi connection will be restored to their original
factory se ings.
To restore the system to the previous firmware version: Use a pin to press
and hold the reset bu on for 10 seconds until you hear a voice saying
"System restored successfully". Then the vacuum-mop will automatically
restart, and the se ings such as scheduled cleanup and Wi-Fi connection
will be restored to their original factory se ings.
Note: A er rese ing or restoring the system, the vacuum-mop needs to be
reconnected to the app, and the relevant se ings in the app will be cleared.
Selecting modes/water levels
You can select different modes and water levels in the Mi Home/Xiaomi
Home app.
Do not disturb (DND) mode
In DND mode, the vacuum-mop will not resume the cleanup, perform
scheduled cleanup, or issue voice alerts. DND mode is enabled by default
from 11:00 p.m. to 9:00 a.m. and can be disabled in the app.
Note: In DND mode, the vacuum-mop's indicator will go off a er the vacuum-mop
being charged for 1 minute.
Cleaning up all areas
If you choose to clean up all areas when no map is saved, the vacuum-mop
will clean square-shaped areas of 6 × 6 meters one by one. A er a map has
and been saved in the app and you select to clean up all areas, the vacuum-mop
will automatically clean each room according to the planned route. And it
will return to the charging dock a er the cleaning is completed.
Saving maps
A er the vacuum-mop quickly creates a map or returns to the charging
dock to charge a er completing a cleaning task, the updated map will be
automatically saved in the Mi Home/Xiaomi Home app. Once a map has
been created, you can use the app to split or merge areas, or customize
room names.
Edge cleanup
A er you select the edge cleanup in the app, the vacuum-mop will
automatically identify the area to be cleaned and clean along the edges.
A er cleaning, the vacuum-mop will automatically return to the charging
dock to charge.
Zoned cleanup
You can set up a zoned cleanup in the app, and the vacuum-mop will clean
the areas you select.
Note: Zoned cleanup cannot completely keep the vacuum-mop inside the selected
areas during cleaning. Remove any obstacles around the areas prior to cleaning in
case the vacuum-mop goes out of the selected areas.
Clean there
You can use the clean there feature in the app to set a target point on the
map. The vacuum-mop will automatically navigate to the target point and
clean a square-shaped area of 2 × 2 meters with the target point as the
center.
12