UNITED OFFICE UAV 190 B2 Bedienungsanleitung Seite 8

Operation
nOTe
► As every shredder is tested for functionality after manufacture, it is possible
that you may find paper residue in the cutting blades .
● Place the shredder on a suitable container:
place the broad end of the appliance on the edge of the container . Then pull
out the telescopic arm 6 until it sits securely on the other edge .
● Insert the plug into a mains power socket .
Operation
CauTIOn! MaTerIal DaMaGe!
using auto mode
● Set the switch 1 to the "AUTO" for shredding . The power LED 4 lights up
green . The motor starts automatically as soon you insert paper and switches
off automatically once no further paper is inserted .
NOTE
► Always insert smaller pieces of paper into the middle of the cutter opening 2 .
This is where the contact that starts the cutting process is located .
NOTE
► If the appliance overheats, the overheat LED 5 lights up as soon as the paper
touches the contact which starts the cutting process . The appliance will not
start cutting . Proceed as described in the section "Note regarding overheating
of the appliance" .
UAV 190 B2
You can shred up to 6 sheets (80 g /m
Remove all paper clips or staples before inserting the paper into
the cutter opening 2 . The cutting blades might otherwise be
damaged .
paper) at the same time .
2
GB │ IE │ NI │ CY
│ 5 ■