RS Pro RS-125H Bedienungsanleitung Seite 4

Moisture Meter / English
Wood
A
Rio rosewood Yellow birch
Common beech Southem yellow pine
Red oak Hombeam
Teak Hickory-silver poplar
Willow hickory-poplar
White oak Izombe
Cedar Guanandi
Cypress-C.Lusit Jarrah
Board Elm
Karri
Chestnut-sweet,red
African
5.2 Select wood group in building mode (01,02,03,04)
There are four building material groups selectable, you can switch among them by press
"SET" key. Just which building material are grouped under 01,02,03 and 04 can be found in
the table 2.
Table2 Building materials group
1 02
Gypsum plaster Aerated concrete
05 06
anhydrite screed ardurapid cement screed B25 cement
09 10
Elastizel screed gypsum screed
13 14
DIN magnesuim expanded polystyrene
oxychloride flooring
17 18
cement screed with cement screed with
bitumen additive plastic additive
4
B
Common aspen
Damson wood
Cypress,red
Fibre board
Wood fibre insulating board
Wood fibre hardboard
Kauramin partide board
Paper
Textiles
Building materials
03 04
Screed Concrete
07 08
B35 cement
11 12
wood cement screed lime mortar
15 16
softboard(wood) with cement bonded
bitumen chipboard
19
cement mortar
5.3 Wet/Moist/Dry indicator
In addition to the built-in material, a wet/moist/dry indicator is displayed for evaluating
the moisture of other material (refer to table2). The moisture level is divided into
DRY,MOIST,WET three grades, you can set the wet and dry threshold values in the setting
menu, and then you evaluate the moisture level by the indicator.
The Dry/Wet index value of the indicator is programmable, about the detail please refer to
chapter 6.2.
Almost Dry
When measure build materials 5~19, The recommended DRY threshod value is 70 and WET
threshold value is 850, and you can evaluate the moisture level by the following table:
All values in material moisture %
5 6 7 8
>0.9 >1.2 >1.8 >2.3 >2.8 >1.2 v>10 >2.5 >3.6 >3.2 >2.8
WET
MOIST
0.9~0.5 1.2~0.9 1.8~1.4 2.3~1.8 2.8~1.6 1.2~0.6 10~6.2 2.5~1.6 3.6~3.2 3.2~2.8 2.8~1.5
<0.5 <0.9 <1.4 <1.8 <1.6 <0.6 <6.2 <1.6 <3.2 <2.8 <1.5
DRY
5.4 Self -Test mode
(1) Connect electrodes with "B" contacts to the protective cap.
Moisture Meter / English
In Moist area In Wet area
9 10 11 12 17
Test approved Test not approved
18 19
5