RS Pro RS-060 Bedienungsanleitung Seite 3

Video Borescope / English
4. Feature Layout
1. LCD Screen: 2.4" TFT LCD screen.
2. Power Button: Press and release to turn the instrument on and off.
3. Worklight Up Button: Increases the brightness of the cameramounted LEDs up
to 100. Press and hold to change quickly.
4. Worklight Down Button: Decreases the brightness of the cameramounted LEDs
down to 0 (off). Press and hold to change quickly.
3
5. Mirror/Auto Power Off Button: Short press mirrors the display over the x-axis.
Long press enables auto power off mode. Short presses in auto power off mode
change auto power off time (off, 5 minutes, 10 minutes).
6. Camera Input Socket: Screw into place once the camera output plug is inserted.
7. USB Charging Port: Attach the borescope to a computer via USB to charge
battery. Attach to included 5V adapter to charge via a standard power outlet.
8. Camera Head: Contains the CMOS sensor and LEDs. The arrow on top indicates
the camera is right-side up.
9. Gooseneck: Rated to IP67 to withstand all ingress of dust and submersion in
water up to 1 meter. Caution: bending the gooseneck to 90 degrees or greater
can permanently damage it.
10. Camera Output: Attaches to borescope body when the notch is oriented
correctly.
5. SETUP
Charging
The rechargable lithium-ion battery should be charged before operating the
borescope for the first time. The battery can be charged via a standard 120V wall
outlet or through a computer USB port. An exhausted battery will take up to 5
hours to charge. It can be left charging overnight without needing to be removed
from power. The expected lifetime of the included battery is 500 charging cycles.
WALL OUTLET: Locate the power wall
adapter (f) and the USB cable (g). Remove
the soft input cover and plug the cable
into the borescope's USB port (7). Plug
the other end of the cable into the power
adapter, and plug the wall adapter into a
standard 120V outlet.
COMPUTER: Locate the USB cable (g).
Remove the soft input cover and plug the
cable into the borescope's USB port (7).
Plug the rectangular end into your
computer's USB port.
Attaching the Gooseneck Camera
Locate the gooseneck camera (10). Plug
it into the camera input socket of the
borescope. Rotate the adjustment piece
clockwise to lock it into place. The
white arrow on the camera head should
be pointing up.
Powering ON/Off
To power the unit on and off, press and release the power button (2). The borescope
will be operational in a few moments.
Video Borescope / English
4