Getting Started; Unpacking; Inserting Batteries Into The Remote; Rack Mounting - Sony PCM-R300 Bedienungsanleitung

Getting Started

Getting Started

Unpacking

Check that you have received the following supplied
items:
• AC power cord (1)
• Remote commander (remote) RM-D757 (1)
• Size-AA (R6) batteries (2)
• Rack mount adaptors (2)
• Screws (M5 × 12) (4)
• Decorative washers (4)
• Decorative panel (1)
• Tapping screws (3 × 8) (2)
• Operating instructions (1)

Inserting batteries into the remote

Insert two size-AA (R6) batteries, matching the + and –
on the batteries with the markings inside the battery
compartment.
z
When to replace the batteries
With normal use, batteries should last for about 6
months. When the remote no longer operates the deck,
replace both batteries.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign matter into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
illumination as doing so may cause malfunction.
• When not using the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
EN
4

Rack Mounting

You can use the supplied rack mount adaptor to install
your deck in a 19-inch 3U-size rack. Be sure to turn the
deck off before you install it.
Remove the screws (M3 × 10) from the sides of the
1
deck.
Screw (M3 × 10)
2
Position the rack mount adaptors onto the sides of
the deck as shown below and secure them with
the screws removed in step 1.
Rack mount adaptor
Screw (M3 × 10)
3
If necessary, attach the decorative panel with the
tapping screws (3 × 8).
The decorative panel covers the space that forms
below the deck.
Tapping screw (3 × 8)
4
Insert the deck into the rack and secure it with the
supplied decorative washers and screws (M5 ×
12).
Rack
Decorative washer
Screw (M5 × 12)