Herunterladen Diese Seite drucken

cecotec CONGA 8290 IMMORTAL ULTRA POWER X-TREME Bedienungsanleitung Seite 61

Vorschau ausblenden Andere Handbücher für CONGA 8290 IMMORTAL ULTRA POWER X-TREME:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 79
1.
Unscrew the screws on the lower housing, remove the latter, and take out the battery.
2. Insert the new battery.
3. Put the battery and the lower housing back in place and re-tighten the screws.
5. TROUBLESHOOTING
Problem
The robot vacuum cleaner does
not switch on or does not clean.
The robot vacuum cleaner cannot
charge or return to the charging
base.
The robot vacuum cleaner does
not work properly.
The robot vacuum cleaner makes
a strange noise during operation.
The robot vacuum cleaner does
not clean efficiently or doesn't
pick up all the dirt.
Possible cause and solution
The robot vacuum cleaner does not work when
battery is low. Allow it to charge before operation.
The room temperature is below 0 ºC or above 40 ºC.
There are too many obstacles near the charging
base. Relocate the charging base to an area free of
obstacles.
Clean the charging terminals of both the charging
base and the robot vacuum cleaner.
Make sure the robot vacuum cleaner is switched on.
The robot vacuum cleaner is too far away from the
charging base. Place it closer and try again.
Turn off the robot vacuum cleaner and turn it on
again.
Reset the robot vacuum cleaner by pressing the side
Reset button.
The main brush, side brush, or omnidirectional
wheel are blocked or tangled. Stop the robot vacuum
cleaner and clean them.
The tank is full. Empty it and clear the high-efficiency
filter if it is blocked.
The high-efficiency filter is blocked. Clean it.
The main brush is blocked or tangled. Clean it.
CONGA 8290 IMMORTAL ULTRA POWER X-TREME
ENGLISH
61

Werbung

loading