clage FX Next Gebrauchs- Und Montageanleitung Seite 34

7. How to use
Automatic (only models with motor valve)
In this menu, two functions can be selected . Automatic either measures
EN
the time in seconds via the function "Duration" or the flow of heated
water in litres via the function "Fill-Up" (fig . B3) . Cold water added at the
tap cannot be recorded by the appliance . In order to use the Automatic
function correctly according to the fill quantity, it is therefore necessary
to set the desired temperature and only turn on the hot water tap .
For each function per user profile, the last set start value is saved and
can be activated at any time .
Note: In Automatic mode, the operating functions are limited. When
selecting a limited function, an instruction window appears. Select "OK"
to deactivate Automatic mode and all functions are freely available again.
Tap on "Cancel" to close the instruction window and Automatic mode
remains active.
Duration: Under "Duration", set the desired time and then select
"START" to activate Automatic mode . The view changes to the main
control where the set time is displayed to the right of the temperature
display (fig . B4) .
Turn on the hot water tap to start the function and the time starts to
count down as seconds . Turning off the tap does not pause the function .
If hot water is already flowing whilst the function is activated, it starts
immediately .
To cancel the function, tap on menu button and confirm the message
with "OK" .
When the time has elapsed, a message appears . In addition, the flow
quantity, if it is being drawn, is reduced for around 5 seconds and then
increased again .
Fill-Up: Under "Fill-Up" set the desired water quantity and then select
"START" to activate Automatic mode . The view changes to the main con-
trol where the set quantity is displayed to the right of the temperature
display (fig . B5) . Turning on the hot water tap starts the function and the
set fill quantity counts down in litre increments according to the flow
measurement .
Continued turning off and on of the tap pauses and restarts the function .
If hot water is already flowing whilst the function is activated, it starts
immediately . To cancel the function, tap on menu button and confirm
the message with "OK" or turn off the water flow for a minute .
When the fill quantity is reached, a message appears on the display and
the appliance stops the water flow by closing the motor valve . The motor
valve stay closed until the message is confirmed at the appliance, remote
control or via app .
24