Atag HG7692A Bedienungsanleitung Seite 31

FAULTS
If the appliance does not work properly, it does not always mean that it is
defective. Try to deal with the problem yourself first. Phone the service
department if the advice given below does not help. Only authorised
personnel may carry out work on the gas and electrical part.
fault cause
There is a smell of gas in the – A burner is turned on but not lit.
vicinity of the appliance.
– The coupling on a bottled gas
unit has come undone.
A burner does not ignite. – Burner parts not correctly
installed.
– Fuse defective/fuse in meter
cabinet switched off.
– Plug not in socket.
– Sparkplug dirty/damp.
– Burner parts dirty/damp.
– Ventilation opening at the rear
closed.
– Main gas tap closed.
– Fault in the gas network.
– Gas bottle or tank is empty.
– Control knob not kept pressed
in long enough or far enough .
The burner does not burn evenly. – Burner parts incorrectly installed.
– Burner parts dirty or damp.
– Wrong type of gas used (where
bottled gas is used).
The burner goes out after igniting. – Control knob not kept pressed
in long enough (H7692B).
58
table
solution
– Close the tap and wait for a few
minutes before relighting.
– Tighten the coupling.
– Assemble the burner parts using
the centring ridges.
– Fit a new fuse or switch the
automatic fuse back on.
– Push the plug into the socket.
– Clean and dry the sparkplug.
– Clean and dry the burner parts,
making sure that the outflow
holes are open.
– Ensure adequate air supply.
– Open the main gas tap.
– Check with your gas supplier.
– Connect a new gas bottle or
have the tank filled.
– Keep the control knob pressed
in far enough between full and
low for at least 5 seconds.
– Assemble the burner parts using
the centring ridges.
– Clean and dry the burner parts,
checking that the outflow holes
are open.
– Check that the gas used is
suitable for the appliance.
– Keep the control knob pressed
in for at least 5 seconds.
ENVIRONMENTAL ASPECTS
In the manufacturing of this appliance use has been made of durable
materials. At the end of its lifecycle this appliance must be disposed of in
a responsible manner. The authorities can advise you on this.
The appliance packaging is recyclable. The following may have been
used:
• cardboard;
• paper;
• polythene film (PE);
• CFC-free polystyrene (PS hard foam);
• polypropylene tape (PP).
Dispose of these materials in a responsible manner and in accordance
with government regulations.
disposal of packaging and appliance
59