L
The logs for possible fractures
o
The outlet
o
5.9.1 Replace:
If necessary the
o
chips/embers.
5.9.2 Cleaning the glass
Most of the deposits can be removed with a
dry cloth. You can use ceramic hob cleaner to
clean the glass.
Note: prevent fingerprints on the glass. these
will be burned into it once the appliance is
used and cannot be removed anymore!
Carry-out the check-up according to the
instructions in chapter 7 "checking the
installation"
5.10 Conversion to a different type of
gas (e.g. propane)
This can only be done by installing the proper
burner unit. for this purpose get in touch with
your supplier.
Always mention the type and serial number of
the appliance when ordering.
5.11 Calculation of flue system
The possibilities for the lengths of flue pipes
and the possible restrictors have been
recorded in a table (see chapter 12.) This table
works with a vertical and a horizontal length.
To define the vertical length all
lengths of flue pipes in a vertical
direction should be added up.
The roof terminal always
-
counts as 1 metre.
To define the horizontal length all
lengths of flue pipes in a horizontal
direction should be added up.
-
every 90° bend in the
horizontal part counts as
2 metres.
every 45° bend in the
-
horizontal part counts as
1 metre.
Turns from vertical to
-
horizontal or vice versa are
not reckoned in the
calculation.
The wall terminal always
-
counts as 1 metre.
If there is transit under 45° then the real
vertical and horizontal lengths should be
calculated.
54 <
<
<
<
5.11.1 Points of particular interest:
You should never start with a cut-
down pipe from the appliance.