SELFSAT SNIPE PRO Bedienungsanleitung Seite 21

D. Fix the mounting plate with 4 pcs of bolts using spanner
D-1
E. Cable holder installation 1
E-1
Equipment to initiate Cable holder installation
E-3
Arrange cable holder in front of (30cm apart from) antenna center by facing open side of cable holder
toward projected part of the mounting plate. Then attach friction tape outside of cable holder
E-4
Make 15mm drill hole in the center of the tape
marking
20
D-2
E-2
Insert cables like picture
E-5
Insert Receiver & 5c Power cable through the
hole