Troubleshooting - Silvercrest SPS 5000 A1 Bedienungsanleitung

NOTE
► If you close the lid
switched on, the light will turn off automatically. It switches back
on automatically when you open the lid

Troubleshooting

The power bank does not charge
♦ Connection may be faulty. Check the connection.
♦ Some computers deactivate the power supply to the USB ports
when they are turned off. Check that the computer is turned on.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
♦ The charging current of the connected device is too low (< 80 mA)
or too high (> 2.1 A).
♦ The internal overcurrent protection may have been triggered.
Disconnect the attached device and connect the microUSB
charging port
section Charging the power bank).
Afterwards, the power bank can be used again.
NOTE
► If you cannot solve the problem with the above-mentioned solu-
tions, please contact the Service Hotline (see section Service).
SPS 5000 A1
of the power bank while the light is
to start the charging process.
to a power source for a short while (see
again.
GB
│
11 ■