Sennheiser ew 300 IEM G2 Bedienungsanleitung Seite 63

Neue Abbildung
16
All manuals and user guides at all-guides.com
Connecting the transmitter to the mains
CAUTION! Damage due to electric current!
If you connect the transmitter to an unsuitable power supply,
this can cause damage to the device.
Use the supplied mains cable to connect the receiver to the
mains (100 to 240 V AC, 50 or 60 Hz).
Ensure a reliable mains ground connection of the receiver –
especially when you are using multi-outlet power strips or
extension cables.
Both transmitters have no mains switch.
To connect the transmitter to the mains:
Pass the cable through the cable grip
Connect the supplied mains cable to the 3-pin IEC mains socket
Plug the mains connector into the wall socket.
To disconnect the transmitter from the mains:
Pull out the mains connector from the wall socket.
Connecting the amplifier/mixing console
Connect the amplifier/mixing console to the XLR-3F sockets
MONO) or (right).
Both balanced and unbalanced connection is possible (see "Connector
assignment" on page 39).
Note:
Any device that is only suitable for mono operation must be connected to
XLR-3F socket . In this case, set the transmitter to mono operation via
the menu.
Via the "Sensitiv" menu, adjust the transmitter's input sensitivity (see
"Adjusting the sensitivity (transmitter only)" on page 30).
Connecting the headphones/ monitoring the audio signal
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
Set the volume for the connected headphones to the
minimum before putting the headphones on.
To monitor the audio signal:
Set the headphone volume control
to the left as far as possible.
Connect headphones with a ¼" (6.3 mm) stereo jack plug to the
headphone output (PHONES)
Gradually turn up the volume.
.
to the lowest volume by turning it
.
.
(left and