Werbung
Verfügbare Sprachen
Verfügbare Sprachen
in half circle. If the running belt is too loose when your feet are on the running belt, the running
belt and rollers will slip. But it is also not good if it is too tight, it may increase the load on the
motor and damage the motor, running belt, and rollers.
4. Running belt deviation adjustment
All treadmills need to be adjusted before they are shipped from the factory and after they are
installed. However, after a period of time, they may still run off the track. There may be several
reasons for this phenomenon:
1).The host is not placed flat;
2).The user's feet are not in the center of the running belt during exercise;
3).When the user exercises, the feet are not evenly stressed, which will artificially cause the
running belt to deviate. It can be restored to a normal state after a few minutes of no-load
running. For the deviation of the running belt that cannot be automatically restored, you can
use the 6mm Allen key in the accessory kit to adjust step by step with a quarter of a circle as
the unit. The deviation of the running belt is not covered by the warranty. The user can perform
maintenance according to the instruction manual. The deviation will seriously damage the
running belt, so it must be discovered and corrected in time.
The running belt shifts to the
right, tighten the right side
Fine adjustment of the left
and right balance
1. Running belt skidding: When a person is running, the running belt has the phenomenon of
idling or momentary pause;
2. Adjusting the running belt: Tighten the screws on the left and right sides of the running belt,
turn it clockwise three times, and then adjust according to the deviation direction of the running
belt. If it shifts to the right, adjust the right side; if it shifts to the left, adjust to the left side, until
the running belt is centered.
Note: Whether it is to adjust the running belt's elasticity or offset, it should be adjusted when the
machine is no-load running at the lowest gear speed, and the rotation of the adjusting bolt is half
a turn, while adjusting and observing to avoid causing machine damage.
The running belt shifts to the
left, tighten the left side
Fine adjustment of the left
and right balance
US/UK
14
Werbung
